Kia Niro: Sunroof / Sunroof Assembly Repair procedures

Replacement
  

When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

Put on glove to protect your hands.

1.

Remove the roof trim.

(Refer to Roof Trim - "Roof Trim Assembly")

2.

Remove the sunroof glass.

(Refer to Sunroof - "Sunroof Glass")

3.

Loosen the mounting screws and remove the sunroof motor (A).

4.

Remove the drain hose (A) and assist handle guide plate (B).

5.

Remove the sunroof assembly (A) after loosening the nuts and bolts.

Tightening torque :

Bolt : 7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 lb·ft)

Nut : 3.9 - 5.9 N·m (0.4 - 0.6 kgf·m, 2.9 - 4.3 lb·ft)

6.

Install in the reverse order of removal.

  

Make sure to initialize the motor.

Sunroof Assembly Components and components location
Components 1. Sunroof assembly ...

Sunroof Sunshade Repair procedures
Replacement 1. Remove the sunroof assembly. (Refer to Sunroof - "Sunroof Assembly") 2. Remove the drip rail assembly (A) after loose ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Safety Plug Description and operation
Description Safety Plug is installed on the rear side of the high voltage battery and it can mechanically shut the high voltage circuit off when servicing the high voltage system (i.e. High Voltage Battery, Power Relay Assembly, HPCU, BMS ECU, Hybrid Drive Motor, Inverter, HSG, LD ...

Kia Niro 2017 (DE HEV) Service Manual: Cruise Control Switch Repair procedures
Inspection Measuring Resistance 1. Disconnect the cruise control switch connector from the control switch. 2. Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed). ...

© 2016-2024 www.kniro.net