Kia Niro: Drive Belt System / Crankshaft Damper Pulley Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Engine Mechanical System / Drive Belt System / Crankshaft Damper Pulley Repair procedures

Removal and Installation

1.	Remove the RH front wheel. (Refer to Suspension System - "Wheel")

2.	Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")

3.	Remove the drive belt. (Refer to Drive Belt System - "Drive Belt")

Remove the crankshaft damper pulley (A).

Tightening torque :

[64.7 - 71.6 N·m (6.6 - 7.3 kgf·m, 47.7 - 52.8 Ib·ft)] + [39 - 41°]

Using the SST (09231-2M100, 09231-2J210) to hold the crankshaft damper pulley.

5.	Install in the reverse order of removal.

Drive Belt Tensioner Repair procedures

Removal and Installation 1. Remove the drive belt. (Refer to Drive Belt System - "Drive Belt") 2. Remove the mechanical tensioner (A ...

Engine And Transaxle Assembly

...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Crash Pad Side Cover Components and components location
Component Location [LH] 1. Crash pad side cover [LH] [RH] 1. Crash pad side cover [RH] ...

Kia Niro 2017 (DE HEV) Service Manual: Power Relay Assembly (PRA) Description and operation
Description The Power Relay Assembly (PRA) consists of the positive and negative main relays, pre-charge relay, pre-charge resistor and battery current sensor. It is located inside the battery pack assembly and controls the high voltage power circuit between the high voltage batte ...