Kia Niro: Drive Belt System / Drive Belt Tensioner Repair procedures

Removal and Installation
1.

Remove the drive belt.

(Refer to Drive Belt System - "Drive Belt")

2.

Remove the mechanical tensioner (A).

Tightening torque :

18.6 - 23.5 N·m (1.9 - 2.4 kgf·m, 13.7 - 17.4 lb·ft)

3.

Remove the hydraulic tensioner.

(1)

Check that the hydraulic tensioner spring is compressed.

(2)

Unfasten the hydraulic tensioner mounting bolt (A).

(3)

Unfasten the hydraulic tensioner center bolt (B).

(4)

Remove the hydraulic tensioner mounting bolt (A).

(5)

Remove the hydraulic tensioner (C).

Tightening torque :

27.5 - 31.4 N·m (2.8 - 3.2 kgf·m, 20.3 - 23.1 lb·ft)

4.

Install in the reverse order of removal.

Inspection

Check the belt tensioner for excessive dust, crack, and damage. Replace if necessary.

Idler Repair procedures
Removal and Installation 1. Remove the drive belt. (Refer to Drive Belt System - "Drive Belt") 2. Remove the idler (A). ...

Crankshaft Damper Pulley Repair procedures
Removal and Installation 1. Remove the RH front wheel. (Refer to Suspension System - "Wheel") 2. Remove the engine room under cover. ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Rear Seat Back Cover Repair procedures
Replacement    Put on gloves to protect your hands.    • Use a plastic panel removal tool to remove interior trim pie ...

Kia Niro 2017 (DE HEV) Service Manual: Gear Actuator Assembly Repair procedures
Removal    • Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure to follow the safety instr ...

© 2016-2023 www.kniro.net