Inspection |
1. |
Connect the KDS/GDS on the Data Link Connector (DLC). |
2. |
Switch "ON" the ignition. |
3. |
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
|
Removal |
1. |
Switch "OFF" the ignition and disconnect the negative (-) battery terminal. |
2. |
Disconnect the accelerator position sensor connector (A).
|
3. |
Remove the accelerator position sensor after loosening the mounting nuts (A).
|
Installation |
1. |
Install in the reverse order of removal. |
Kia Niro 2017 (DE HEV) Service Manual: Cylinder Head Repair procedures
Removal
Engine removal is not required for this procedure.
•
Be sure to read and follow the “General Safety Information and
Caution” before doing any work related with the high vol ...
Kia Niro 2017 (DE HEV) Service Manual: Steering Gear Rack, Linkage and Boots Repair procedures
Inspection
1.
Check the steering wheel free road.
(1)
Turn the steering wheel so that the front wheels can face straight
ahead.
(2)
Measure the distance the steering wheel can be turned without
...