Removal |
1. |
Disconnect the battery negative terminal, and wait for at least three minutes before beginning to work. |
2. |
Remove the roof trim. (Refer to Body (Interior and Exterior) - "Roof trim assembly") |
3. |
Disconnect the connector (A) from the curtain airbag module.
|
4. |
Loosen the curtain airbag bolts and nuts and then remove the curtain airbag. |
Installation |
1. |
Disconnect the battery negative terminal, and wait for at least three minutes before beginning to work. |
2. |
Install the curtain airbag and then loosen the bolts and nuts.
|
3. |
Connect the curtain airbag connector. |
4. |
Install the loof trim. (Refer to Body (Interior and Exterior) - "Loof trim assembly") |
5. |
Reconnect the battery negative terminal. |
6. |
After installing the curtain airbag (CAB), confirm proper system operation: • Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
|
Kia Niro (DE HEV) Owners Manual: USB
✽ NOTICE - Using the USB Devices
Starting the vehicle while a USB device is connected can damage the device.
Please disconnect USB devices before starting the vehicle.
Starting the vehicle or stopping the engine while an external USB device
is connected can result in failure of the ext ...
Peugeot 2008 2019-2022 Owner's Manual: Direction indicators
Left or right: lower or raise the lighting control stalk, beyond the
point of resistance.
If you forget to cancel
the direction indicators for more than 20 seconds, the volume of the audible
signal will increase if the speed is above 50 mph (80 km/h).
Three flashes
Press briefly upwards o ...