Kia Niro: The components of hybrid vehicle / If An Accident Occurs

WARNING

WARNING

If a vehicle accident occurs:

1.Stop the vehicle and shift the transmission into "P" position. And then depress the parking brake.
2.Turn off the Hybrid system by pushing the Engine Start/Stop Button.
3.Evacuate to the safety place.
4.Call emergency services for help and let them know the vehicle is a Hybrid vehicle.

Do not touch high voltage cables, connectors and package modules. High voltage components are orange in color.

Exposed cables or wires may be visible inside or outside of the vehicle. Never touch the wires or cables, because an electrical shock may occur causing injury or death.

WARNING

If a submersion in water occurs:

If your vehicle was flooded and has soaked carpeting or water on the flooring, you should not try to start the Hybrid system. Never touch the high voltage cables, connectors and package modules, because an electrical shock may occur causing injury or death. High Voltage cables are orange in color.

We recommend that the car towed to an authorized Kia dealer.

Virtual Engine Sound System (VESS)
The Virtual Engine Sound System generates an engine sound for pedestrians to hear vehicle while at low speeds in EV mode. Hybrid battery air intake The hybrid battery air intake is located on bo ...

When the hybrid vehicle shuts off
When the high voltage battery or 12- volt battery discharges, or fuel tank is empty, the hybrid system may not operate. If the Hybrid system stops operating while the vehicle is moving, reduce the ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Thermostat Repair procedures
Removal and Installation    Disassembly of the thermostat may have an adverse effect, causing deteriorated cooling efficiency. Do not remove the thermostat, even if the engine tends to overheat. ...

Kia Niro (DE HEV) Owners Manual: To set speed limit
1. Press the CRUISE & SPEED LIMIT MODE ( ) button twice on the steering wheel, to turn the system on. The speed limit indicator light will illuminate. 2. Move the lever down (to SET-). 3. Move the lever up (to RES+) or down (to SET-), and release it at the desired speed. Move the ...

© 2016-2024 www.kniro.net