Kia Niro: The components of hybrid vehicle / When the hybrid vehicle shuts off

When the high voltage battery or 12- volt battery discharges, or fuel tank is empty, the hybrid system may not operate.

If the Hybrid system stops operating while the vehicle is moving, reduce the vehicle speed gradually. Pull your vehicle off the road in a safe area, and shift the transmission in to Park (P) position and;

1.Turn on the hazard warning flashers.

2.Set the start button at OFF, and try to start the Hybrid system by applying the brake pedal and pushing the start button.

3.If the Hybrid system will not operate, refer to "EMERGENCY STARTING" in chapter 7.

Before you try to jump start the vehicle, confirm the fuel level. If the fuel level is low add more fuel before attempting as emergency start.

WARNING - Accident Vehicle

Never touch electric wires or cable. If exposed electric wires or cables are visible inside or outside of your vehicle, an electric shock may occur.

WARNING - Putting out fire

Never use a small quantity of water to put out a fire in your vehicle. If a fire occurs, evacuate the car immediately and contact the fire department.

If An Accident Occurs
Avoid the engine compartment. Avoid any orange or high voltage wires, cables, or components. Assume that a high voltage component is exposed and move away from the vehicle as promptly as pos ...

Your vehicle at a glance
...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Audio Unit Components and components location
Components [RADIO/CD/MP3] Connector Pin Information No. Connector A Connector B 1 Rear left speaker (+) - 2 Rear left speaker (-) MIC (+) ...

Kia Niro 2017 (DE HEV) Service Manual: Rear Wheel Speed Sensor Repair procedures
Removal 1. Remove the tire. 2. Disconnect the wheel speed sensor connector (A). 3. Loosen the bearing bolts (A) and then remove the hub bearing assembly. Tightening torque: 88.2 - 10 ...

© 2016-2021 www.kniro.net