Peugeot 2008: Lighting and visibility / Headlamp beam height adjustment

Manually adjusting the halogen or LED technology headlamps

Peugeot 2008. Headlamp beam height adjustment

To avoid dazzling other road users, the height of these headlamp beams should be adjusted according to the load in the vehicle.

0 (Initial setting)

Driver only or driver + front passenger

1 5 people

2 5 people + load in the boot

3 Driver only + load in the boot

4 5 6 Not used

This information is provided as a guide only.

Depending on version, the unused positions may be required.

Automatic adjustment of the Full LED  technology headlamps

This system automatically adjusts the height of the headlamp beams according to the load in the vehicle.

Peugeot 2008. Headlamp beam height adjustment In the event of a malfunction, this warning lamp comes on on the instrument panel, accompanied by the display of a message and an audible signal.

The system then places the headlamp beams in the lowest position.

Have the system checked by a PEUGEOT dealer or a qualified workshop.

Peugeot 2008. Headlamp beam height adjustment Do not touch the LED or Full LED  technology headlamps - risk of electrocution!

Direction indicators
Left or right: lower or raise the lighting control stalk, beyond the point of resistance. If you forget to cancel the direction indicators for more than 20 seconds, the volume of the audible ...

Automatic illumination of headlamps
When the ring is at the  "AUTO" position and a low level of ambient light is detected by the rain/sunshine sensor, the number plate lamps,   sidelamps and dipped beam headlamps are switche ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: General safety information and caution
Safety Precaution Precautions to take before servicing high voltage system    Hybrid vehicles have high voltage batteries. Incorrect handling of high voltage sy ...

Kia Niro (DE HEV) Owners Manual: Windshield wipers
Operates as follows when the ignition switch is turned ON. (1) MIST/ : For a single wiping cycle, move the lever to this (MIST/ ) position and release it. The wipers will operate continuously if the lever is held in this position. (2) OFF / O : Wiper is not in operation (3) INT / --- : Wipe ...

© 2016-2021 www.kniro.net