Kia Niro: Rear Seat / Rear Seat Cushion Cover Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Seat Cushion Cover Repair procedures

Replacement

Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Be careful not to bend or scratch the trim and panels.

1.	Remove the seat assembly. (Refer to Rear Seat - "Rear Seat Assembly")

2.	Remove the rear seat cushion cover (A) after removing the hog-ring clips on the rear of seat cushion cover. [Back side] [Inside]

Install in the reverse order of removal.

•	Make sure that the connectors are plugged in properly.

•	Replace any damaged clips.

•	To prevent wrinkles, make sure that the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).

•	Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).

Rear Seat Cushion Cover Components and components location

Component Location 1. Rear seat cushion cover ...

Rear Back Armrest Components and components location

Component Location 1. Rear back armrest ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Repair procedures
Removal In case of bad quality or poor focus, be sure to check the camera lense surface condition and foreign materials. 1. Disconnect the negative (-) battery terminal. ...

Kia Niro 2017 (DE HEV) Service Manual: Smart Key Unit Components and components location
Components Connector Pin Information No. Connector A Connector B Connector C 1 Battery (+) IGN2 relay_output Immoblizer antenna (+)_output 2 Battery ...