Kia Niro: Lighting System / Overhead Console Lamp Repair procedures

Inspection
1.

Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.

Removal
1.

Disconnect the negative (-) battery terminal.

2.

Remove the two mounting screws.

And then remove the overhead console (A).

3.

Remove the overhead console after disconnecting the connectors (A).

Installation
1.

Install the overhead console lamp after connecting the connector.

2.

Install the lens after tightening 2 screws.

Vanity Lamp Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Detach the vanity lamp (A) using a flat-tip screwdriver. 3. ...

Hazard Lamp Switch Repair procedures
Inspection 1. Check for continuity between terminals. If the continuity is not as specified, replace the hazard lamp switch. [Audio Type] Connector Pin ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Dual Clutch Assembly Repair procedures
Removal 1. Remove the hybrid drive motor & dual clutch transmission assembly from the vehicle. (Refer to DCT System - "DCT") 2. Remove the hybrid drive motor assembly from the DCT assembly. (Refer to Hybrid Motor System ...

Kia Niro 2017 (DE HEV) Service Manual: Specifications
Specifications Memory Power Seat Unit Item Specifications Rated voltage DC 12 V Operating voltage DC 9 - 16 V Operating temperature range -22 - 167°F (-30 - 75°C) ...

© 2016-2023 www.kniro.net