Kia Niro: Lighting System / Hazard Lamp Switch Repair procedures

Inspection
1.

Check for continuity between terminals. If the continuity is not as specified, replace the hazard lamp switch.

[Audio Type]

Connector Pin Information

No.
Description
No.
Description
1
Battery (+)
21
IGN2
2
-
22
IGN1
3
Illumination (+)
23
Blower PWM
4
Sensor REF (5V)
24
Left Photo Sensor (-)
5
Driver side mode control actuator feedback
25
Right Photo Sensor (-)
6
Driver side temperature control actuator feedback
26
Blower relay
7
Intake actuator feedback
27
-
8
Evaporator temperature sensor
28
PTC relay 2
9
Ambient temperature
29
PTC relay 1
10
Driver side mode control actuator (Vent)
30
-
11
Driver side mode control actuator (Defogging)
31
Detent Out
12
Driver side temperature control actuator (Cool)
32
Hazard signal
13
Driver side temperature control actuator (Warmer)
33
P-CAN (High)
14
Intake actuator (FRE)
34
P-CAN (Low)
15
Intake actuator (REC)
35
Climate CAN (High)
16
HTD
36
Climate CAN (Low)
17
Rear defogging switch
37
Interlock (+)
18
Clean signal
38
Interlock (-)
19
Cluster Ionizer diagnosis
39
Sensor ground
20
Illumination (-)
40
Ground

[AVN Type]

No.
Description
No.
Description
1
Ground
7
-
2
-
8
Hazard switch_output
3
-
9
-
4
Hazard switch_input
10
-
5
-
11
-
6
Battery (+)
12
-

Removal

[Audio Type]

1.

Remove the heater & A/C control unit.

(Refer to Heating,Ventilation And Air Conditioning - "Heater & A/C Control Unit (DATC)")

[AVN Type]

1.

Remove the AVN head unit.

(Refer to Body Electrcal System - "AVN Head Unit")

Installation

[Audio Type]

1.

Install the heater & A/C control unit.

(Refer to Heating,Ventilation And Air Conditioning - "Heater & A/C Control Unit (DATC)")

[AVN Type]

1.

Install the AVN head unit.

(Refer to Body Electrcal System - "AVN Head Unit")

Overhead Console Lamp Repair procedures
Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. ...

Rheostat Components and components location
Components ...

Other information:

Peugeot 2008 2019-2023 Owner's Manual: Welcome
Thank you for choosing a Peugeot 2008 or a   Peugeot e-2008. This document presents the key information and recommendations required for you to be able to explore your vehicle in complete safety. We strongly recommend familiarising yourself with this document and the Warranty and Maintenanc ...

Peugeot 2008 2019-2023 Owner's Manual: Speed limiter
Refer to the General recommendations on the use of driving and manoeuvring aids. This system prevents the vehicle from exceeding the speed programmed by the driver (speed setting). The speed limiter is switched on manually. The minimum speed setting is 19 mph (30  km/h). The speed setting re ...

© 2016-2023 www.kniro.net