Kia Niro: Intake And Exhaust System / Muffler Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Engine Mechanical System / Intake And Exhaust System / Muffler Repair procedures

Removal and Installation

Front Muffler

1.	Disconnect the heated oxygen sensor connector (A) and then remove it from the bracket.

Remove the under cover (A).

Tightening torque :

7.8 - 9.8 N·m (0.8 - 1.0 kgf·m, 5.8 - 7.2 lb·ft)

3.	Detach the rubber hanger (A) from the front muffler.

Remove the front muffler (B).

Tightening torque :

39.2 - 58.8 N·m (4.0 - 6.0 kgf·m, 28.9 - 43.4 lb·ft)

When installing, replace with new gaskets.

5.	Install in the revere order of removal.

Center Muffler

1.	Detach the rubber hanger (A) from center muffler.

Remove the center muffler (B).

Tightening torque :

39.2 - 58.8 N·m (4.0 - 6.0 kgf·m, 28.9 - 43.4 lb·ft)

When installing, replace with new gaskets.

3.	Install in the reverse order of removal.

Rear Muffler

1.	Detach the rubber hanger (A) from rear muffler.

Remove the rear muffler (B).

Tightening torque :

39.2 - 58.8 N·m (4.0 - 6.0 kgf·m, 28.9 - 43.4 lb·ft)

When installing, replace with new gaskets.

3.	Install in the reverse order of removal.

Muffler Components and components location

Components 1. Front muffler 2. Exhaust heat recovery system (EHRS) 3. Center muffler 4. Rear muffler 5. Gasket 6. Rubber hanger ...

Lubrication System

...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Normal Condition General market
Normal Maintenance Schedule - For Gasoline Engine [Except Europe (Including Russia)] The following maintenance services must be performed to ensure good emission control and performance. Keep receipts for all vehicle emission services to protect your warranty.Where both mileage ...

Kia Niro 2017 (DE HEV) Service Manual: Components and components location
Components 1. Blind Spot Detection (BSD) Unit 2. BSD switch 3. Speaker 4. BSD warning lamp 5. Cluster ...