Kia Niro: Body Electrical System / High voltage shut-off procedures

High voltage components:

High Voltage Battery Pack Assembly, Power Relay Assembly (PRA), BMS ECU, Hybrid Power Control Unit (HPCU), Hybrid Drive Motor, HSG, Electric A/C Compressor, Low DC/DC Converter (LDC), Power Cable, Electric Compressor etc.

Turn the ignition switch OFF and disconnect the auxiliary 12V battery negative (-) terminal.

Remove the safety plug cover (A) under the rear seat..

Unfasten the hook (A) to the direction of arrow.

Unfasten the lever (A) to the direction of arrow.

Remove the safety plug (A).

Wait at least 5 minutes or until the capacitor in the high voltage system is fully discharged.

Measure the voltage between the inverter terminals to check that the capacitor in the inverter is discharged completely.

(2)	Disconnect the inverter power cable (A). Disconnect the inverter power cable as the procedures below.

(3)

Measure the voltage between the inverter (+) terminal and the inverter (-) terminal. Less than 30V : High voltage circuit properly shut More than 30V : Fault on high voltage circuit If measured more than 30V, check if the safety plug is removed completely.If measured more than 30V despite the safety plug is removed, there can be serious problems on the high voltage circuit. In this case, check DTC and never touch the high voltage system circuits.