Kia Niro: ESP(Electronic Stability Program) System / Emergency Signal System Description and operation

Kia Niro 2017 (DE HEV) Service Manual / Brake System / ESP(Electronic Stability Program) System / Emergency Signal System Description and operation

Description

Introduction of quick brake warning system (ESS)

In case of quick brake by driver, the brake lamp or turn signal is blinked to warn against the vehicle at rear.

Basic function (Blinking the brake lamp/emergency lamp)

–	Operation condition: In case of quick brake or operation of ABS above in a certain speed

–	Releasing condition: In case of stopping the quick brake or releasing the ABS operation

Additional function (Blinking the turn signal)

–	Operation condition: In case of quick brake in low speed

–	Releasing condition: Releasing at the start of driving

System configuration

ESS Circuit diagram

ESP OFF Switch Repair procedures

Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - ...

Assist Emergency Braking(AEB) System

...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Knock Sensor (KS) Description and operation
Description Knocking is a phenomenon characterized by undesirable vibration and noise that can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking. When knocking occurs, the vibration from the cylinder block is applied as pressure ...

Kia Niro 2017 (DE HEV) Service Manual: Seat Belt Buckle Switch (BS) Description and operation
Description The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status input. The seat belt buckle circuit operates from internal boost voltage supplied by the SR ...