Kia Niro: Blind spot detection / Lane change assist / Warning type
The system will activate when:
1.The system is on
2.Vehicle speed is above 30 km/h (18.6 mph)
3.Other vehicles are detected in the rear side
1st stage
If a vehicle is detected within the boundary of the system, a warning light will illuminate on the outside rearview mirror.
If the detected vehicle is not in detection range, the warning will be turned off.
2nd stage
The second stage alarm will activate when:
1. The first stage alert is on
2. The turn signal is on to change a lane
When the second stage alert is activated, a warning light will be blinking on the outside rearview mirror and an alarm will sound.
If you move the turn signal switch to origin position, the second stage alert will be deactivated.
- The second stage alarm can be deactivated.
- To activate the alarm:
Go to the User Settings Mode → Sound and select Blind Spot Detection Sound on the LCD display. - To deactivate the alarm:
Go to the User Settings Mode → Sound and deselect Blind Spot Detection Sound on the LCD display.
CAUTION
The alarm function helps alert the driver. Deactivate this function only when it is necessary
Operating conditions
The indicator on the switch will illuminate when the Blind spot detection system
switch is pressed with the ignition switch ON. If the vehicle speed exceeds 30 km/h
(18.6 mph), the system will a ...
Detecting sensor
The sensors are located inside the rear bumper.
Always keep the rear bumper clean for the system to work properly. ...
Other information:
Kia Niro (DE HEV) Owners Manual: Selecting a Child Restraint System (CRS)
When selecting a Child Restraint System for your child, always:
Make sure the Child Restraint System has a label certifying that it meets
applicable Safety Standards of your country. A Child Restraint System may only
be installed if it was approved in accordance with the requirements of EC ...
Kia Niro 2017 (DE HEV) Service Manual: Sunroof Deflector Repair procedures
Replacement
1.
Open the glass fully.
2.
Remove the mounting pins (B), and then remove the deflector (A).
3.
Install in the reverse order of removal.
...