Kia Niro: Blind spot detection / Lane change assist / Detecting sensor

The sensors are located inside the rear bumper.

Always keep the rear bumper clean for the system to work properly.

Warning type
The system will activate when: 1.The system is on 2.Vehicle speed is above 30 km/h (18.6 mph) 3.Other vehicles are detected in the rear side 1st stage If a vehicle is detected within the bounda ...

Warning message
The message (“Blind Spot Detection disabled temporarily”) will appear to notify the driver if there are foreign substances on the rear bumper or it is hot near the rear bumper. The light on th ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Muffler Repair procedures
Removal and Installation Front Muffler 1. Disconnect the heated oxygen sensor connector (A) and then remove it from the bracket. 2. Remove the under cover (A). Tightening torque : 7.8 - 9.8 N·m (0.8 - 1.0 ...

Kia Niro 2017 (DE HEV) Service Manual: Rear Wheel Speed Sensor Components and components location
Components 1. Rear wheel speed sensor ...

© 2016-2020 www.kniro.net