Kia Niro: Ignition switch position / START

Turn the ignition key to the START position to start the engine. The engine will crank until you release the key; then it returns to the ON position. The brake warning lamp can be checked in this position.

WARNING - Ignition key

ON
The warning lights can be checked before the engine is started. This is the normal running position after the engine is started. Do not leave the ignition switch ON if the engine is not running to ...

Starting the hybrid system
WARNING Always wear appropriate shoes when operating your vehicle. Unsuitable shoes, such as high heels, ski boots, sandals, flip-flops, etc., may interfere with your ability to use the brak ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Blower Motor Repair procedures
Inspection 1. Operate the heater controls at IGN2 to ensure that the motor is running. 1. Battery (+) 2. Input signal 3. ? 4. Ground 2. If the blower motor does ...

Kia Niro 2017 (DE HEV) Service Manual: Troubleshooting
Troubleshooting Symptom Possible cause Remedy Hard steering Improper front wheel alignment Excessive turning resistance of lower arm ball joint Low tire pressure No power assist Correct Replac ...

© 2016-2021 www.kniro.net