Kia Niro: Steering wheel / Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Steering System / Steering wheel / Repair procedures

Removal

1.	Disconnect the battery negative cable.

2.	Turn the steering wheel so that the front wheels are facing straight ahead.

3.	Remove the driver airbag module. (Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")

4.	Disconnect the connector.

Loosen the bolt (A) and then remove the steering wheel.

Tightening torque:

39.2 - 49.0 N·m (4.0 - 5.0 kgf·m, 28.9 - 36.1 lb·ft)

•	Do not hammer on the steering wheel to remove it; it may damage the steering column.

•	Do not reuse the bolt.

6.	Install in the reverse order of removal.

Disassembly

1.	Disconnect the negative battery cable.

2.	Remove the steering wheel assembly. (Refer to Steering System -"Steering wheel")

3.	Loosen the screw and then remove the steering back cover.

4.	Disconnect the remote control switch connector.

5.	Loosen the screw and then remove the remote control switch.

6.	Disconnect the heated pad connector.

7.	Loosen the screw and then remove the remote control switch from the bezel.

8.	Loosen the bolts and then remove the damper.

9.	Install in the reverse order of removal.

Components and components location

Components 1. Bezel 2. Lower cover 3. Damper 4. Steering wheel 5. Remote control switch 6. Wire ring ...

Heated Steering wheel Description and operation

Description When manually selected, the heated steering wheel system improves the thermal comfort of the driver by heating the steering wheel. Specifications Item ...

Other information:

Kia Niro (DE HEV) Owners Manual: Passenger’s front air bag OFF indicator
The passenger’s front air bag OFF indicator illuminates for about 4 seconds after the ignition switch is turned to the ON position. The passenger’s front air bag OFF indicator also comes on when the passenger’s front air bag ON/OFF switch is set to the OFF position and goes off when t ...

Kia Niro 2017 (DE HEV) Service Manual: Muffler Repair procedures
Removal and Installation Front Muffler 1. Disconnect the heated oxygen sensor connector (A) and then remove it from the bracket. 2. Remove the under cover (A). Tightening torque : 7.8 - 9.8 N·m (0.8 - 1.0 ...