Kia Niro: Blind spot detection / Lane change assist / Warning type

The system will activate when:

1.The system is on

2.Vehicle speed is above 30 km/h (18.6 mph)

3.Other vehicles are detected in the rear side

1st stage

If a vehicle is detected within the boundary of the system, a warning light will illuminate on the outside rearview mirror.

If the detected vehicle is not in detection range, the warning will be turned off.

2nd stage

The second stage alarm will activate when:

1. The first stage alert is on

2. The turn signal is on to change a lane

When the second stage alert is activated, a warning light will be blinking on the outside rearview mirror and an alarm will sound.

If you move the turn signal switch to origin position, the second stage alert will be deactivated.

- The second stage alarm can be deactivated.

CAUTION

The alarm function helps alert the driver. Deactivate this function only when it is necessary

Operating conditions
The indicator on the switch will illuminate when the Blind spot detection system switch is pressed with the ignition switch ON. If the vehicle speed exceeds 30 km/h (18.6 mph), the system will a ...

Detecting sensor
The sensors are located inside the rear bumper. Always keep the rear bumper clean for the system to work properly. ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Front Seat Assembly Repair procedures
Replacement 1. Loosen the front seat mounting bolts (A). Tightening torque : 49.0 - 58.8 N·m (5.0 - 6.0 kgf·m, 36.2 - 43.4 lb·ft) [Front] [Rear] 2. Disconnect the airbag connect ...

Kia Niro 2017 (DE HEV) Service Manual: Safety Plug Description and operation
Description Safety Plug is installed on the rear side of the high voltage battery and it can mechanically shut the high voltage circuit off when servicing the high voltage system (i.e. High Voltage Battery, Power Relay Assembly, HPCU, BMS ECU, Hybrid Drive Motor, Inverter, HSG, LD ...

© 2016-2024 www.kniro.net