Peugeot 2008: Driving / Visiopark 1

Refer to the General recommendations on the use of driving and manoeuvring aids.

Peugeot 2008. Visiopark 1

As soon as reverse gear is engaged with the engine running, this system displays views of your vehicle’s close surroundings on the touch screen using a camera located at the rear of the vehicle.

Peugeot 2008. Visiopark 1

The screen is divided into two parts with a contextual view and a view from above the vehicle in its close surroundings.

The parking sensors supplement the information on the view from above the vehicle.

Various contextual views may be displayed:

AUTO mode is activated by default.

In this mode, the system chooses the best view to display  (standard or zoom).

You can change the type of view at any time during a manoeuvre.

The system status is not saved when the ignition is switched off.

Principle of operation

Peugeot 2008. Visiopark 1

Using the rear camera, the vehicle's close surroundings are recorded during manoeuvres at low speed.

An image from above your vehicle in its close surroundings is reconstructed (represented between the brackets) in real time and as the manoeuvre progresses.

It facilitates the alignment of your vehicle when parking and allows obstacles close to the vehicle to be seen. It is automatically deleted if the vehicle remains stationary for too long.

Rear vision

Peugeot 2008. Visiopark 1

To activate the camera, located on the tailgate, engage reverse and keep the speed of the vehicle below 6 mph (10  km/h).

The system is deactivated:

AUTO mode

Peugeot 2008. Visiopark 1

This mode is activated by default.

Using sensors in the rear bumper, the automatic view changes from the rear view (standard) to the view from above (zoom) as an obstacle is approached at the level of the red line (less than 30  cm) during a manoeuvre.

Standard view

Peugeot 2008. Visiopark 1

The area behind the vehicle is displayed on the screen.

The blue lines 1 represent the width of your vehicle, with the mirrors unfolded; their direction changes according to the position of the steering wheel.

The red line 2 represents a distance of 30  cm from the rear bumper; the two blue lines 3 and 4 represent 1  m and 2  m, respectively.

This view is available with AUTO mode or in the view selection menu.

Zoom view

Peugeot 2008. Visiopark 1

The camera records the vehicle's surroundings during the manoeuvre in order to create a view from above the rear of the vehicle in its near surroundings, allowing the vehicle to be manoeuvred around nearby obstacles.

This view is available with AUTO mode or in the view selection menu.

Peugeot 2008. Visiopark 1 Obstacles may appear further away than they actually are.

It is important to monitor the sides of the vehicle during the manoeuvre, using the mirrors.

Parking sensors also provide additional information about the area around the vehicle.

180° view

Peugeot 2008. Visiopark 1

The 180° view facilitates reversing out of a parking space, making it possible to see the approach of vehicles, pedestrians and cyclists.

This view is not recommended for carrying out a complete manoeuvre.

It features 3 areas: left A, centre B and right C.

This view is only available via the view selection menu.

Parking sensors
Refer to the General recommendations on the use of driving and manoeuvring aids. Using sensors located in the bumper, this system signals the proximity of obstacles (e.g.   pedestrian, vehicle ...

Park Assist
Refer to the General recommendations on the use of driving and manoeuvring aids. This system provides active parking assistance: it detects a parking space and then steers in the appropriate directi ...

Other information:

Peugeot 2008 2019-2022 Owner's Manual: Steering wheel adjustment
When stationary, pull the control to release the steering wheel. Adjust the height and reach to suit your driving position. Push the control lever to lock the steering wheel. As a safety measure, these adjustments must only be carried out with the vehicle stationary. ...

Toyota Corolla 2019-2022 Owners Manual: Battery
Check the battery as follows. ■ Battery exterior Make sure that the battery terminals are not corroded and that there are no loose connections, cracks, or loose clamps. A - Terminals B - Hold-down clamp ■ Before recharging When recharging, the battery produces hydrogen gas which is flammable a ...

© 2016-2022