Kia Niro: Engine Control System / Variable Force Solenoid (VFS) Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Engine Control/Fuel System / Engine Control System / Variable Force Solenoid (VFS) Repair procedures

Removal

1.	Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

2.	Disconnect the VFS connector (A).

Remove the mounting bolts (B), and then remove the VFS from the engine.

Variable force solenoid mounting bolt :

9.8 - 11.8 N·m (1.0 - 1.2 kgf·m, 7.2 - 8.7 lb·ft)

Installation

•	Install the component to the specified torque.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing

1.	Install in the reverse order of removal.

Variable Force Solenoid (VFS) Schematic diagrams

Circuit Diagram Harness Connector ...

CVVT Oil Control Valve (OCV) Specifications

Specification Item Specification Coil Resistance (Ω) 6.9 - 7.9 [20°C(68°F)] Rated Voltage (V) 12 ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Inspection mode procedures
Procedure for entering engine forced activation mode If the engine needs to be run constantly while the vehicle is stopped to inspect emission gas or perform maintenance on the vehicle, follow the below procedure to enter forced engine activation mode. 1. Place ...

Kia Niro 2017 (DE HEV) Service Manual: Brake Actuation Unit Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery terminal. 2. Disconnect the TCM connector. (Refer to DCT (Dual Clutch Transmission) System - "DCT Control Module (TCM)) 3. Disco ...