Kia Niro: If you have a flat tire (with tire mobility kit) / Using the TMK

1. Detach the speed restriction label (1) from the sealant bottle (2), and place it in a highly visible place inside the vehicle such as on the steering wheel to remind the driver not to drive too fast.

■ 18 inch tire

2. Screw connection hose (10) onto the connector of the sealant bottle. (18 inch tire only)

■ 16 inch tire

2. Connect the filling hose (3) onto the connector of the sealant bottle (A). (16 inch tire only)

3. Ensure that button (9) on the compressor is not pressed.

■ 18 inch tire

4.Unscrew the valve cap from the valve of the flat tire and screw filling hose (3) of the sealant bottle onto the valve.

5.Insert the sealant bottle into the housing (5) of the compressor so that the bottle is upright.

6.Ensure that the compressor is switched off, position 0.

7. Connect between compressor and the vehicle power outlet using the cable and connectors.

8.With the engine start/stop button position on or ignition switch position on, switch on the compressor and let it run for approximately 5~7 minutes to fill the sealant up to proper pressure. (refer to the Tire and Wheels, chapter 9). The inflation pressure of the tire after filling is unimportant and will be checked/corrected later.

Be careful not to overinflate the tire and stay away from the tire when filling it.

When the tire and wheel are damaged, do not use Tire Mobility Kit for your safety.

CAUTION - Tire pressure

Do not attempt to drive your vehicle if the tire pressure is below 250 kPa (36 psi/2.5 bar). This could result in an accident due to sudden tire failure.

9.Switch off the compressor.

10. Detach the hoses from the sealant bottle connector and from the tire valve.

Return the TMK to its storage location in the vehicle.

WARNING - Carbon monoxide

Carbon monoxide poisoning and suffocation is possible if the engine is left running in a poorly ventilated or unventilated location (such as inside a building).

Components of the Tire Mobility Kit (TMK)
■ 18 inch tire 1. Speed restriction label 2. Sealant bottle and label with speed restriction 3. Filling hose from sealant bottle to wheel 4. Connectors and cable for the battery direct connect ...

Distributing the sealant
11. Immediately drive approximately 7~10km (4~6miles or, about 10min) to evenly distribute the sealant in the tire. CAUTION Do not exceed a speed of 60 km/h (35 mph). If possible, do not fall belo ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Troubleshooting
Troubleshooting Trouble Symptom Probable cause Remedy Vehicle pulls to one side Scoring of driveshaft ball joint Replace Wear, rattle or scoring of wheel bearing Replace ...

Kia Niro 2017 (DE HEV) Service Manual: Inhibitor Switch Description and operation
Description • The inhibitor switch is installed on top of transmission, and is connected to the shift lever through shift cable. • Inhibitor switch signals (S1, S2, S3, S4) are transmitted to the TCM according to the driver's shif ...

© 2016-2024 www.kniro.net