Kia Niro: Driving with a trailer / Turn signals when towing a trailer
When you tow a trailer, your vehicle has to have a different turn signal flasher and extra wiring. The green arrows on your instrument panel will flash whenever you signal a turn or lane change. Properly connected, the trailer lights will also flash to alert other drivers you’re about to turn, change lanes, or stop.
When towing a trailer, the green arrows on your instrument panel will flash for turns even if the bulbs on the trailer are burned out. Thus, you may think drivers behind you are seeing your signals when, in fact, they are not. It is important to check occasionally to be sure the trailer bulbs are still working. You must also check the lights every time you disconnect and then reconnect the wires.
Do not connect a trailer lighting system directly to your vehicle’s lighting system. Use only an approved trailer wiring harness.
An authorized Kia dealer can assist you in installing the wiring harness.
WARNING
Failure to use an approved trailer wiring harness could result in damage to the vehicle electrical system and/or personal injury.
Driving with a trailer
Towing a trailer requires a certain amount of experience. Before setting out
for the open road, you must get to know your trailer. Acquaint yourself with the
feel of handling and braking with the ...
Driving on grades
Reduce speed and shift to a lower gear before you start down a long or steep
downgrade. If you don’t shift down, you might have to use your brakes so much that
they would get hot and no longer o ...
Other information:
Toyota Corolla 2019-2023 Owners Manual: Using the mechanical key (vehicles with a smart key system)
To take out the mechanical key, slide the release button and take the key out.
The mechanical key can only be inserted in one direction, as the key only has
grooves on one side. If the key cannot be inserted in a lock cylinder, turn it over
and re-attempt to insert it. After using the mechanical k ...
Kia Niro (DE HEV) Owners Manual: List of voice commands
Voice command types
• Voice commands are categorized into ‘Global Commands’ and ‘Local Commands.’
1) Global Commands (●): Commands that can be used immediately after voice recognition
is started.
2) Local Commands (O): Commands that can be used when radio, media or Bluetooth®
pho ...
