Kia Niro: Lighting System / Turn Signal Lamp Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Body Electrical System / Lighting System / Turn Signal Lamp Repair procedures

Removal

Door Mirror Turn Signal Lamp

1.	Disconnect the negative (-) battery terminal.

Remove the mirror (A) from the mirror holder.

Be careful not to damage the fixing clips (A).

3.	Disconnect the heating connectors (A) and BSD indicator connector (B) from the mirror.

4.	Remove the door mirror housing (A) after loosening the mounting screws.

5.	Remove the door mirror cover (A) after separating the mounting clips.

6.	Remove the door mirror turn signal lamp (A) after loosening the screw.

7.	Disconnect the connector (A) from the door mirror turn signal lamp (B).

Installation

1.	Install the door mirror turn signal lamp.

2.	Install the door mirror cover.

3.	Install the door mirror housing.

4.	Install the door mirror.

5.	Connect the negative (-) battery terminal.

Headlamps Repair procedures

Inspection 1. Check the battery voltage. (Low beam will be on when the battery voltage is above 9 V.) 2. Check the fuse and relay. ...

Room Lamp Repair procedures

Removal • Put on gloves to prevent hand injuries. • ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Components and components location
Component Location Index [Engine Room] 1. Ambient Temperature Sensor 2. Receiver-drier 3. Condenser 4. Compressor 5. Discharge hose 6. The service port (voltage) 7. The service port (high pressure) 8. A/C Pressure Transducer (APT) ...

Kia Niro 2017 (DE HEV) Service Manual: Rear Washer Switch Repair procedures
Inspection Multifunction Switch Inspection 1. Check for continuity between the terminals in each switch position as shown below. [Left Handle Drive] Switch Switch position Switch terminal ...