Kia Niro: Steering wheel / Tilt & telescopic steering
A tilt and telescopic steering wheel allows you to adjust the steering wheel before you drive.You can also raise it to give your legs more room when you exit and enter the vehicle.
The steering wheel should be positioned so that it is comfortable for you to drive, while permitting you to see the instrument panel warning lights and gauges.
WARNING
- Never adjust the angle of the steering wheel while driving. You may lose steering control and cause severe personal injury, death or accidents.
- After adjusting, push the steering wheel both up and down to be certain it is locked in position.
To change the steering wheel angle, pull down the lock release lever (1), adjust the steering wheel to the desired angle (2) and height (3), then pull up the lock-release lever (4) to lock the steering wheel in place. Be sure to adjust the steering wheel to the desired position before driving.
✽ NOTICE
After adjustment, sometimes the lock-release lever may not lock the steering wheel.
It is not a malfunction. This occurs when two gears engage. In this case, adjust the steering wheel again and then lock the steering wheel.
Electronic power steering
Power steering uses the motor to assist you in steering the vehicle. If the engine
is off or if the power steering system becomes inoperative, the vehicle may still
be steered, but it will require ...
Heated steering wheel
With the ignition switch in the ON position or engine start/stop button in the
ON position, pressing the heated steering wheel button warms the steering wheel.
The indicator on the button will i ...
Other information:
Kia Niro (DE HEV) Owners Manual: SRS components and functions
The SRS consists of the following components:
1. Driver's front air bag module
2. Passenger's front air bag module*
3. Side air bag modules*
4. Curtain air bag modules*
5. Retractor pre-tensioner assemblies*
6. Air bag warning light
7. SRS control module (SRSCM)
8. Front impact sen ...
Kia Niro 2017 (DE HEV) Service Manual: Brake Line Repair procedures
Removal
1.
Disconnect the brake fluid level switch connector, and remove the reservoir
cap.
2.
Remove the brake fluid from the master cylinder reservoir with a syringe.
...
