Storing driver’s seat positions
1. Shift the shift lever into P while the engine start/stop button is ON or ignition switch ON.
2. Adjust the driver’s seat and outside rearview mirror comfortable for the driver.
3. Press SET button on the control panel. The system will beep once.
4. Press one of the memory buttons (1 or 2) within 4 seconds after pressing the SET button. The system will beep twice when memory has been successfully stored.
Recalling positions from memory
1. Shift the shift lever into P while the engine start/stop button is ON or ignition switch ON.
2. To recall the position in the memory, press the desired memory button (1 or 2). The system will beep once, then the driver’s seat will automatically adjust to the stored position.
Adjusting the control switch for the driver’s seat while the system is recalling the stored position will cause the movement to stop and move in the direction that the control switch is moved.
WARNING
Use caution when recalling the adjustment memory while sitting in the vehicle. Push the seat position control switch to the desired position immediately if the seat moves too far in any direction.
Kia Niro 2017 (DE HEV) Service Manual: Virtual Engine Sound Speaker Repair procedures
Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
3.
Remove the high pitch horn and low pitch horn.
(Refer to Body Electric ...
Kia Niro 2017 (DE HEV) Service Manual: General safety information and caution
Safety Precaution
Precautions to take before servicing
high voltage system
Since hybrid vehicles contain a high voltage battery, if the
high voltage system o ...