Kia Niro: SRSCM / SRS Control Module (SRSCM) Description and operation

Kia Niro 2017 (DE HEV) Service Manual / Restraint / SRSCM / SRS Control Module (SRSCM) Description and operation

Description

The primary purpose of the SRSCM (Supplemental Restraints System Control Module) is to determine between an event that warrants restraint system deployment and an event that does not. The SRSCM must decide whether to deploy the restraint system or not. After determining that pretensioners and/or airbag deployment is required, the SRSCM must supply sufficient power to the pretensioners and airbag igniters to initiate deployment.

The SRSCM determines that an impact may require deployment of the pretensioners and airbags from data obtained from impact sensors and other components in conjunction with a safing function.

The SRSCM will not be ready to detect a crash or to activate the restraint system devices until the signals in the SRSCM circuitry stabilize.

It is possible that the SRSCM could activate the safety restraint devices in approximately 2 seconds but is guaranteed to fully function after prove-out is completed.

The SRSCM must perform a diagnostic routine and light a system readiness indicator at key-on. The system must perform a continuous diagnostic routine and provide fault annunciation through a warning lamp indicator in the event of fault detection. A serial diagnostic communication interface will be used to facilitate servicing of the restraint control system.

SRSCM
...

SRS Control Module (SRSCM) Components and components location
Components ...

Other information:

Kia Niro (DE HEV) Owners Manual: Assist emergency braking (AEB)
The AEB system is to reduce or to avoid accident risk. It recognizes the distance from the vehicle ahead or the pedestrian through the sensors (i.e. radar and camera), and, if necessary, warns the driver of accident risk with the warning message or the warning alarms. WARNING Take the follow ...

Kia Niro 2017 (DE HEV) Service Manual: Evaporator Core Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater - "Heater Unit") 3. Remove the heater unit lower case (A) after loosening the mounting ...

© 2016-2024 www.kniro.net