Removal |
The side airbag cannot be disassembled from the seat back assembly, so replace the seat back assembly when replacing the side airbag. |
1. |
Disconnect the battery negative terminal, and wait for at least three minutes before beginning to work. |
2. |
Remove the front seat assembly. (Refer to Body (Interior and Exterior) - "Front seat assembly") |
3. |
Remove the seat back assembly. (Refer to Body (Interior and Exterior) - "Front seat back cover") |
4. |
Loosen the side air bag module nuts and then remove the air back module.
|
Installation |
1. |
Disconnect the battery negative cable, and wait for at least three minutes before beginning to work. |
2. |
Install the air back module and then tightening the side air bag module nuts.
|
3. |
Install the seat back assembly. (Refer to Body (Interior and Exterior) - "Front seat back cover") |
4. |
Install the front seat assembly. (Refer to Body (Interior and Exterior) - "Front seat assembly") |
5. |
Reconnect the battery negative terminal. |
6. |
After installing the side airbag (PAB), confirm proper system operation: • Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off. |
Kia Niro 2017 (DE HEV) Service Manual: BMS ECU Schematic diagrams
BMS ECU Terminal And Input/Output
Signal
Connector [B01-VC] (24pin) : High Voltage
Battery Cell Voltage Check Connector
Pin No.
Description
Connected to
1
-
-
2
...
Kia Niro 2017 (DE HEV) Service Manual: Center Pillar Trim Components and components location
Component Location
1. Center pillar lower trim
2. Center pillar upper trim
...