Kia Niro: Dual Clutch Transmission Control System / Shift Lever Repair procedures

Removal
1.

Shift the gear to "N".

2.

Remove the knob (A) by pulling it in the direction of arrow after removing the boots from the console upper cover.

3.

Remove the floor console assembly.

(Refer to Body - "Floor Console")

4.

Disconnect the main connector (A).

5.

Remove the shift cable.

(1)

Remove the shift cable from the shift lever pim after removing the snap pin (A).

(2)

Remove the cable socket (B) from the shift lever.

6.

Remove the shift lever assembly (B) by loosening bolts and then remove the wiring mounting clips (A).

Tightening torque:

8.8 - 13.7 N·m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb·ft)

Installation
1.

Install in the reverse order of removal.

  

Check that the shift lever and manual control lever are placed in the "N" position.

Shift Lever Components and components location
Components 1. Shift lever knob & boots 2. Shift lever assembly 3. Shift cable assembly ...

Shift Cable Components and components location
Components 1. Shift lever knob & boots 2. Shift lever assembly 3. Shift cable assembly ...

Other information:

Kia Niro (DE HEV) Owners Manual: Climate control air filter
A : Outside air B : Recirculated air C : Climate control air filter D : Blower E : Evaporator core F : Heater core The climate control air filter installed behind the glove box filters the dust or other pollutants that come into the vehicle from the outside through the heating and air co ...

Kia Niro 2017 (DE HEV) Service Manual: Tire (pressure & tread wear) Repair procedures
Inspection 1. Check the tire pressure. 16(inch) : 230 kPa (33 psi) 18(inch) : 230 kPa (33 psi) Tire Rotation Checking For Pull And Wander If the steering pulls to one side, rotate the tires according to the following wheel rotation procedure. ...

© 2016-2024 www.kniro.net