Kia Niro: Hybrid Motor Control System / Resolver Sensor Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Service Highlight / Hybrid Motor Control System / Resolver Sensor Repair procedures

Inspection

Hybrid Drive Motor

Inspect the resolver sensor resistance.

Item	Pin	Specification	Remarks
Resistance (Resolver sensor)	1 - 5	11.7 Ω ± 10 %	At room temperature 68°F (20°C)
	2 - 6	34.5 Ω ± 10 %
	3 - 7	29.5 Ω ± 10 %

2.	If the resolver sensor need to be replaced, hybrid drive motor assembly should be replaced. (Refer to Hybrid Motor Assembly - "Hybrid Drive Motor Assembly")

Hybrid Starter Generator (HSG)

Inspect the resolver sensor resistance.

Item	Pin	Specification	Remarks
Resistance (Resolver sensor)	1 - 4	13.8 - 17.8 Ω	At room temperature 68°F (20°C)
	2 - 5	26.2 - 30.2 Ω
	3 - 6	26.2 - 30.2 Ω

2.	If the resolver sensor need to be replaced, HSG assembly should be replaced. (Refer to Hybrid Motor Assembly - "Hybrid Starter Generator")

Resolver Calibration

Perform the resolver calibration using the KDS / GDS after replacing or reinstalling the below components.

•	Hybrid Drive Motor installation

•	Hybrid Starter Generator (HSG) installation

•	Motor Control Unit (MCU) replacement

•	Engine clutch system replacement

Resolver Sensor Schematic diagrams

Part Circuit Diagram [Hybrid Drive Motor] [HSG] ...

Motor Temperature Sensor Description and operation

Description The motor temperature has the large effect on the motor output. When the motor over heats, it’s IPM and stator coil may deform and their performance may be affected. To ...

Other information:

Kia Niro (DE HEV) Owners Manual: Rear window defroster
The defroster heats the window to remove frost, fog and thin ice from the rear window, while the engine is running. To activate the rear window defroster, press the rear window defroster button located in the center facia switch panel. The indicator on the rear window defroster button illum ...

Kia Niro 2017 (DE HEV) Service Manual: Smart Key Unit Components and components location
Components Connector Pin Information No. Connector A Connector B Connector C 1 Battery (+) IGN2 relay_output Immoblizer antenna (+)_output 2 Battery ...