Kia Niro: Seat Belt System / Pretensioner (BPT) / Repair procedures

Removal
1.

Disconnect the battery negative terminal, and wait for at least three minutes before beginning to work.

2.

Remove the front seat belt anchor (A).

3.

Remove the door scurff trim.

(Refer to Body (Interior and Exterior) - "Door scuff trim")

4.

Remove the center pillar trim.

(Refer to Body (Interior and Exterior) - "Center pillar trim)

5.

Unscrew the top of the seat belt anchor bolts (A).

Tightening torque:

39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)

6.

It separates the seat belt pre-tensioner connector (A).

7.

Loosen the safety belt pretensioner mounting bolt (A, B) and remove the safety belt pretensioners.

Tightening torque

(A):7.8 -11.8 N.m (0.8 - 1.2 kgf.m, 7.8-11.8 lb-ft)

(B):39.2 - 53.9 N.m (4.0 - 5.5 kgf.m,28.9 - 39.8 lb-ft)

Installation
1.

Install in the reverse order of remova.l.

2.

After replacing the safety belt pretensioners must ensure that the system is operating normally.

  

Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off

Components and components location
Components ...

SRSCM
...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Repair procedures
Service Adjustment procedure Steering Wheel Play Inspection 1. Turn the steering wheel so that the front wheels are facing straight ahead. 2. Measure the distance that the steering wheel can be turned without moving the front wheels. ...

Kia Niro (DE HEV) Owners Manual: Recommended cold tire inflation pressures
All tire pressures (including the spare) should be checked when the tires are cold. “Cold Tires” means the vehicle has not been driven for at least three hours or driven less than 1.6 km (one mile). Recommended pressures must be maintained for the best ride, top vehicle handling, and mini ...

© 2016-2024 www.kniro.net