Component Replacement After Deployment |
Before doing any SRS repairs, use the KDS/GDS to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs. |
When the front airbag(s) deployed after a collision, replace the following items.
– |
SRSCM |
– |
Deployed airbag(s) |
– |
Seat belt pretensioner(s) |
– |
Front impact sensors |
– |
SRS wiring harnesses |
– |
Inspect the clock spring for heat damage. If any damage found, replace the clock spring. |
When the side/curtain airbag(s) deployed after a collision, replace the following items.
– |
SRSCM |
– |
Deployed airbag(s) |
– |
Side impact sensor(s) for the deployed side(s) |
– |
SRS wiring harnesses |
After the vehicle is completely repaired, confirm the SRS airbag system is OK.
– |
Turn the ignition switch ON; the SRS indicator should come on for about six seconds and then go off. |
Kia Niro 2017 (DE HEV) Service Manual: Tailgate Latch Repair procedures
Replacement
Put on gloves to protect your hands.
•
Use a plastic panel removal tool to remove interior trim pie ...
Kia Niro 2017 (DE HEV) Service Manual: DCT(Dual Clutch Transmission) Components and components location
Components
1. Hybrid drive motor assembly
2. DCT (Dual Clutch Transmission) assembly
3. Gear actuator assembly
4. DCT support bracket
5. Inhibitor switch
6. Clutch actuator assembly
7. Dual clutch assembly
8. Engine clutch actuator as ...