Kia Niro: Rear Axle Assembly / Rear Hub - Carrier / Repair procedures

Removal
1.

Remove the tire (A).

Tightening torque :

107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)

  

Be careful not to damage the wheel nuts when removing the wheel and tire.

2.

Disconnect the wheel speed sensor connector (A).

3.

Remove the parking brake calbe pin (A).

4.

Rotates the nut (A) in the counterclockwise direction and then remove the parking cable.

5.

Remove the rear brake caliper.

(Refer to Brake System - "Rear Disc Brake")

6.

Remove the rear lower arm and assist arm bolt (A).

Tightening torque :

137.3 - 156.9 N·m (14.0 - 16.0 kgf.m, 101.3 - 115.7 lb-ft)

7.

Remove the rear upper arm bolt (A).

Tightening torque :

137.3 - 156.9 N·m (14.0 - 16.0 kgf.m, 101.3 - 115.7 lb-ft)

8.

Remove the trailing arm nuts (A).

Tightening torque :

137.3 - 156.9 N·m (14.0 - 16.0 kgf.m, 101.3 - 115.7 lb-ft)

9.

Remove the rear axle.

10.

Check the wheel alignment.

(Refer to Suspension System - "Alignment")

Disassembly
1.

Remove the hub bolts (A).

Tightening torque :

88.2 - 107.8 N·m (9.0 - 11.0 kgf·m, 65.0 - 79.5 lb·ft)

2.

Remove the rear disc screw (A).

Tightening torque :

4.9 - 5.8 N·m (0.5 - 0.6 kgf·m, 3.6 - 4.3 Ib·ft)

3.

Remove the dust cover bolts (A).

Tightening torque :

6.8 - 10.7 N·m (0.7 - 1.1 kgf·m, 5.0 - 7.9 lb·ft)

Inspection
1.

Check the hub for cracks and the splines for wear.

2.

Check the rear axle carrier for cracks.

Components and components location
Components 1. Disc 2. Dust cover 3. Rear hub 4. Rear Knuckle ...

Suspension System
...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Description and operation
Description The HCU (Hybrid Control Unit) controls the overall hybrid systems and is connected with each of the control modules (ECM, TCM, MCU, BMS, ECU, etc.) via CAN. The hybrid system is controlled based on the brake switch signals.    ...

Kia Niro 2017 (DE HEV) Service Manual: Sunroof Assembly Repair procedures
Replacement    • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • P ...

© 2016-2024 www.kniro.net