Removal |
1. |
Remove the tire. |
2. |
Disconnect the wheel speed sensor connector (A).
|
3. |
Loosen the bearing bolts (A) and then remove the hub bearing assembly.
|
Inspection |
1. |
Measure the output voltage between the terminal of the wheel speed sensor and the body ground.
|
2. |
Compare the change of the output voltage of the wheel speed sensor to the normal change of the output voltage as shown below.
|
Kia Niro (DE HEV) Owners Manual: If you do decide to pull a trailer
Here are some important points if you decide to pull a trailer:
Consider using a sway control.You can ask a hitch dealer about sway control.
Do not do any towing with your car during its first 2,000 km (1,200 miles)
in order to allow the engine to properly break in. Failure to heed this cau ...
Kia Niro (DE HEV) Owners Manual: Head lamp low beam (RHD)
1. Turn the low beam on without driver aboard.
2. The cut-off line should be projected in the cut-off line shown in the picture.
3. When aiming the low beam, vertical aiming should be adjusted after adjusting
the horizontal aiming.
4. If head lamp leveling device is equipped, adjust the head la ...