Kia Niro: Rear Wiper/Washer / Rear Washer Switch Repair procedures

Inspection

Multifunction Switch Inspection

1.

Check for continuity between the terminals in each switch position as shown below.

[Left Handle Drive]

Switch
Switch position
Switch terminal
Resistance (?, ±3.5%)
Front wiper switch
MIST
1-9
330
OFF
?
Intermittent (AUTO)
800
LOW
1,800
HIGH
5,700
Rear wiper switch
OFF
9-16
?
LOW
910
HIGH
2,910

[Right Handle Drive]

Switch
Switch position
Switch terminal
Resistance (?, ±3.5%)
Front Wiper switch
MIST
3-16
330
OFF
?
Intermittent (AUTO)
800
LOW
1,800
HIGH
5,700
Rear wiper switch
OFF
9-16
?
LOW
910
HIGH
2,910

Inspection (With KDS/GDS)

1.

In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (KDS/GDS).

The diagnostic system(KDS/GDS) provides the following information.

(1)

Self diagnosis : Checking failure and code number (DTC)

(2)

Current data : Checking the system input/output data state

(3)

Actuation test : Checking the system operation condition

(4)

Additional function : Controlling other features including system option setting and zero point adjustment

2.

Select the 'Car model' and the 'Body Control Module (BCM)' to be checked in order to check the vehicle with the tester.

3.

Select the 'Current Data' menu to search the current state of the input/output data.

Rear Wiper Motor Repair procedures
Inspection Rear Wiper Motor 1. Remove the connector from the rear wiper motor. 2. Connect positive (+) battery cables to terminal 4 and negative ...

Rear Washer Motor Repair procedures
Inspection 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water.    ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Repair procedures
Adjustment 1. After loosening the hinge (A) mounting bolts, adjust the hood (B) by moving it up and down, or right and left. 2. Adjust the hood height by turning the hood overslam bumpers (C). 3. After loosening the ...

Kia Niro 2017 (DE HEV) Service Manual: Sunroof Motor Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly") 3. Remove the glass motor (A) after loosening the mounting screws. ...

© 2016-2024 www.kniro.net