Kia Niro: Body Side Molding / Rear Spoiler Repair procedures

Replacement
  

Put on gloves to protect your hands.

  

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Be careful not to bend or scratch the trim and panels.

1.

Remove the tailgate upper trim.

(Refer to Tailgate - "Tailgate Trim")

2.

Remove the anti-pinch strip.

(Refer to Body Electrical System - "Anti-Pinch Strip")

3.

Disconnect the washer nozzle (A) and high mounted stop lamp connector (B).

4.

Remove the cap (A) and then loosen the rear spoiler mounting nuts (A).

Tightening torque :

5.9 - 6.4 N·m (0.6 - 0.65 kgf·m, 4.3 - 4.7 lb·ft)

5.

Remove the rear spoiler (A).

  

Make sure the connector is connected properly.

Replace any damaged clips.

Roof Rack Repair procedures
Replacement    Put on gloves to protect your hands.    ...

Fender Garnish Repair procedures
Replacement    Put on gloves to protect your hands.    ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Hood Latch Components and components location
Component Location 1. Hood lower latch assembly ...

Kia Niro 2017 (DE HEV) Service Manual: Description and operation
Description The Seat Belt Pretensioners (BPT) are installed inside Center Pillar (LH & RH). When a vehicle crashes with a certain degree of frontal impact, the pretensioner seat belt helps to reduce the severity of injury to the front seat occupants by retracting the seat belt ...

© 2016-2022 www.kniro.net