Kia Niro: Rear Suspension System / Rear Shock Absorber Repair procedures

Removal

1.	Disconnect the battery negative cable.

Remove the wheel nuts and tire.

Tightening torque:

107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)

Be careful not to damage the wheel nuts when removing the wheel and tire.

Loosen the rear shock absorber bolts (A).

Tightening torque:

58.8 - 73.5 N·m (6.0 - 7.5 kgf·m, 43.4 - 54.2 lb·ft)

Loosen the nut (A) and then remove the rear shock absorber.

Tightening torque:

98.0 - 117.6 N·m (10.0 - 12.0 kgf·m, 72.3 - 86.7 lb·ft)

5.	Install in the reverse order of removal.

Disassembly

1.	Remove the insulator cap (A).

2.	Loosen the lock nut (A).

3.	Install in the reverse order of removal.

Inspection

1.	Check the rubber parts for wear and deterioration.

2.	Compress and extend the piston rod (A) and check that there is no abnormal resistance or unusual sound during operation.

Disposal

1.	Fully extend the piston rod.

Drill a hole on the (A) section to remove gas from the cylinder.

The gas released is harmless but be careful of chips that may stir up from drilling.

Components 1. Stabilizer bar 2. Rear sub frame 3. Rear upper arm 4. Rear shock absorber 5. Rear axle 6. Assist arm 7. Trailing arm 8. ...

Removal 1. Disconnect the battery negative cable. 2. Remove the wheel and tire. Tightening torque: 107.9 - 127.5 N·m ( ...

Kia Niro 2017 (DE HEV) Service Manual: Rear Disc Brake Repair procedures
Removal 1. Remove the wheel & tire. 2. Remove the parking brake cable pin (A). 3. Rotates the nut (A) in the counterclockwise direction and then remove the parking cable. 4. ...

Kia Niro 2017 (DE HEV) Service Manual: Exhaust Manifold Repair procedures
Removal and Installation 1. Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover") 2. Remove the air cleaner. (Refer to Intake and Exhaust System - "Air Cleaner") ...