Kia Niro: Rear Seat Belt / Rear Seat Belt Retractor Repair procedures

Replacement
  

When installing the belt, be careful not to damage the retractor.

1.

Remove the rear pillar trim.

(Refer to Interior Trim - "Rear Pillar Trim")

2.

Remove the rear seat belt upper anchor (A) after loosening the mounting bolts.

Tightening torque :

39.2 - 53.9 N·m (4.0 - 5.5 kgf·m, 28.8 - 39.8 lb·ft)

3.

Remove the rear seat belt retractor (A) after loosening the mounting bolt.

Tightening torque :

Lower : 39.2 - 53.9 N·m (4.0 - 5.5 kgf·m, 28.8 - 39.8 lb·ft)

Upper : 7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 lb·ft)

4.

Install in the reverse order of removal.

  

Make sure the connector is plugged in properly.

Replace any damaged clips (or pin-type retainers).

Rear Seat Belt Retractor Components and components location
Component Location 1. Rear seat belt retractor ...

Rear Center Seat Belt Retractor Components and components location
Component Location 1. Rear center seat belt retractor ...

Other information:

Kia Niro (DE HEV) Owners Manual: Headlight washer
If your vehicle is equipped with the headlight washer it will operate at the same time when you operate the windshield washer. However, if this function is operated once, the headlight washer will not operate within 15 minutes. It will operate when the headlight is ON and the ignition switch o ...

Kia Niro 2017 (DE HEV) Service Manual: Steering Column Shroud Panel Repair procedures
Replacement    Put on gloves to protect your hands.    • Use a plastic panel removal tool to remove interior trim pie ...

© 2016-2024 www.kniro.net