Kia Niro: Rear Door / Rear Door Latch Repair procedures

Replacement
  

Put on gloves to protect your hands.

  

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Be careful not to bend or scratch the trim and panels.

1.

Remove the rear door module.

(Refer to Rear Door - "Rear Door Module")

2.

Loosen the rear door outside handle base mounting bolt (A).

3.

Remove the rear door latch (B) after loosening the mounting screw (A).

4.

Install in the reverse order of removal.

  

Make sure that the connector is connected properly.

Make sure that the door locks/unlocks and opens/closes properly.

Replace any damaged clips.

Rear Door Latch Components and components location
Component Location 1. Rear door latch ...

Rear Door Belt Outside Weatherstrip Repair procedures
Replacement 1. Pull down the rear door window glass to the lowest level by pressing the power window glass switch. 2. Remove the rear door bel ...

Other information:

Peugeot 2008 2019-2022 Owner's Manual: Media
USB port Insert the USB memory stick into the USB port or connect the USB device to the USB port using a suitable cable (not supplied). To protect the system, do not use a USB hub. The system builds playlists (in temporary memory); this operation can take from a few seconds to several minutes ...

Kia Niro 2017 (DE HEV) Service Manual: Side Airbag (SAB) Module Description and operation
Description The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of side airbag by using Side Impact Sensor (SIS) signal.    ...

© 2016-2022 www.kniro.net