Removal |
Rear Combination Lamp (Outside)
1. |
Disconnect the negative (-) battery terminal. |
2. |
Using a screwdriver or remover, remove the rear combination lamp cover (A).
|
3. |
Remove the rear combination lamp (A) after loosening the screws.
|
4. |
Remove the rear combination lamp packing (A).
|
5. |
Disconnect the rear combination lamp connector (A).
|
Rear Combination Lamp (Inside)
1. |
Disconnect the negative (-) battery terminal. |
2. |
Using a screwdriver or remover, remove the rear combination lamp cover (A).
|
3. |
Disconnect the connector (B) and then remove the rear combination lamp (A) after loosening the nuts.
|
Back up lamp
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the rear bumper cover. (Refer to Body - "Rear bumper Cover") |
3. |
Disconnect the back up lamp connector (A).
|
4. |
Remove the back up lamp (A) after loosening the screws.
|
Bulb Replacement |
Back Up Lamp
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the back up lamp bulb (B) by turning the socket (A) counterclockwise.
|
Installation |
Rear Combination Lamp (Outside)
1. |
Connect the rear combination lamp connector. |
2. |
Install the rear combination lamp. |
3. |
Install the rear combination lamp cover. |
4. |
Connect the negative (-) battery terminal. |
Rear Combination Lamp (Inside)
1. |
Install the rear combination lamp. |
2. |
Connect the rear combination lamp connector. |
3. |
Install the rear combination lamp cover. |
4. |
Connect the negative (-) battery terminal. |
Back Up Lamp
1. |
Install the back up lamp. |
2. |
Install the rear bumper cover. |
3. |
Connect the negative (-) battery terminal. |
Kia Niro 2017 (DE HEV) Service Manual: Brake Pedal Components and components location
Components
1. Pedal stroke sensor
2. Stop lamp switch
3. Brake pedal arm
...
Kia Niro 2017 (DE HEV) Service Manual: Center Pillar Trim Repair procedures
Replacement
[Center pillar lower
trim]
Put on gloves to protect your hands.
•
Use a plastic panel removal to ...