Kia Niro: Rear Suspension System / Rear Coil Spring Repair procedures

Removal

1.	Disconnect the battery negative cable.

Remove the wheel and tire.

Tightening torque:

107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)

Be careful not to damage the wheel nuts when removing the wheel and tire.

Loosen the rear lower arm bolt (A), rear shock absorber bolt (B) and stabilizer link bolt (C) and then remove the rear coil spring.

Tightening torque:

(A) 137.3 - 156.9 N·m (14.0 - 16.0 kgf·m, 101.3 - 115.7 lb·ft)

(B) 98.0 - 117.6 N·m (10.0 - 12.0 kgf·m, 72.3 - 86.7 lb·ft)

Set up the transmission jack under the lower arm in order to remove the shock absorber in no-load condition.

4.	Install in the reverse order of removal.

5.	Check the wheel alignment. (Refer to Suspension System - "Alignment")

Removal 1. Disconnect the battery negative cable. 2. Remove the wheel and tire. Tightening torque: 107.9 - 127.5 N·m ( ...

Removal 1. Disconnect the battery negative cable. 2. Remove the wheel and tire. Tightening torque: 107.9 - 127.5 N·m ( ...

Kia Niro 2017 (DE HEV) Service Manual: Trailing Arm Repair procedures
Removal 1. Disconnect the battery negative cable. 2. Remove the wheel and tire. Tightening torque: 107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft) ...

Kia Niro 2017 (DE HEV) Service Manual: Fuel Pump Control Module (FPCM) Schematic diagrams
Circuit Diagram Terminal Information Terminal Illustration Terminal Function Pin No. Description 1 Fuel Sender (-) 2 Fuel pressure sensor (FPS) signal inpu ...