Kia Niro: Rear Bumper / Rear Bumper beam Assembly Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper beam Assembly Repair procedures

Replacement

Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Be careful not to bend or scratch the trim and panels.

1.	Remove the rear bumper cover. (Refer to Rear Bumper - "Rear Bumper Cover")

2.	Disconnect the rear bumper beam mounting wiring harness (A).

3.	Remove the rear bumper beam assembly (A) after loosening the mounting clips.

Install in the reverse order of removal.

•	Make sure the connector is connected properly.

•	Replace any damaged clips.

Rear Bumper beam Assembly Components and components location

Component Location 1. Rear bumper beam assembly ...

Rear Door

...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Repair procedures
Removal In case of bad quality or poor focus, be sure to check the camera lense surface condition and foreign materials. 1. Disconnect the negative (-) battery terminal. ...

Kia Niro 2017 (DE HEV) Service Manual: Components and components location
Components Location 1. High Voltage Battery System Assembly 2. High Voltage Battery Pack Assembly 3. Power Relay Assembly (PRA) 4. High Voltage Front Cover 5. High Voltage Rear Cover 1. High Voltage Battery System Assemb ...