Kia Niro: Rear Suspension System / Rear Assist Arm Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Suspension System / Rear Suspension System / Rear Assist Arm Repair procedures

Removal

1.	Disconnect the battery negative cable.

Remove the wheel and tire.

Tightening torque:

107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)

Be careful not to damage the wheel nuts when removing the wheel and tire.

Loosen the bolts (A,B) and then remove the rear assist arm.

Tightening torque:

(A) 107.9 - 117.7 N·m (11.0 - 12.0 kgf·m, 79.6 - 86.8 lb·ft)

(B) 137.3 - 156.9 N·m (14.0 - 16.0 kgf·m, 101.3 - 115.7 lb·ft)

Set up the transmission jack under the lower arm in order to remove the shock absorber in no-load condition.

4.	Install in the reverse order of removal.

5.	Check the wheel alignment. (Refer to Suspension System - "Alignment")

Inspection

1.	Check the bushing for wear and deterioration.

2.	Check all bolts and nut.

Rear Stabilizer Bar Repair procedures

Removal 1. Disconnect the battery negative cable. 2. Remove the wheel and tire. Tightening torque: 107.9 - 127.5 N·m ( ...

Trailing Arm Repair procedures

Removal 1. Disconnect the battery negative cable. 2. Remove the wheel and tire. Tightening torque: 107.9 - 127.5 N·m ( ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Components and components location
Component Location 1. Cowl top cover ...

Kia Niro (DE HEV) Owners Manual: Distributing the sealant
11. Immediately drive approximately 7~10km (4~6miles or, about 10min) to evenly distribute the sealant in the tire. CAUTION Do not exceed a speed of 60 km/h (35 mph). If possible, do not fall below a speed of 20 km/h (12 mph). While driving, if you experience any unusual vibration, ride distu ...