Kia Niro: Seat Electrical / Power Seat Motor Repair procedures

Inspection

Power Seat Motor

1.

Disconnect the connectors for each motor.

[Slide motor (A)]

[Rear height motor (B)]

[Front tilt motor (C)]

[Reclining motor (D)]

[Lumber support motor (E)]

2.

When the battery power is supplied to the motor connector, check the motor for smooth operation.

3.

Reverse the connections and check that the motor turns in reverse.

4.

If the motor runs abnormally, replace it.

[Driver]

Reclining Motor Limit Switch

1.

Disconnect the limit switch and operate the limit switch.

2.

Check for continuity between the terminals.

3.

Make sure that the seat operation is normal in the reverse after the maximum operation.

4.

If there is an abnormality, replace the limit switch.

Remove

Front Seat

1.

Disconnect the negative (-) battery terminal.

2.

Remove the front seat assembly.

(Refer to Body - "Front Seat Assembly")

Power Seat Motor Description and operation
Description Power seat motor is driven by a motor in the following. 1. Slide motor 2. Front tilt motor 3. Rear Height ...

Power Seat Control Switch Schematic diagrams
Circuit Diagram [Driver power seat switch] (Non-IMS Type) (IMS Type) ...

Other information:

Peugeot 2008 2019-2022 Owner's Manual: Engine coolant temperature indicator
With the engine running: In zone A, the temperature is correct. In zone B, the temperature is too high; the associated warning lamp and the central STOP warning lamp come on in red on the instrument panel, accompanied by the display of a message and an audible signal. You must stop the vehicle as ...

Kia Niro 2017 (DE HEV) Service Manual: Transmission Gear Oil Repair procedures
Inspection Oil Level Check 1. Remove the under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover") 2. Remove the oil filler plug (A or B). 3. Check the condition of the oil and m ...

© 2016-2022 www.kniro.net