Kia Niro: Power Door Mirrors / Power Door Mirror Switch Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Body Electrical System / Power Door Mirrors / Power Door Mirror Switch Repair procedures

Inspection

[Non-IMS Type]

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front left door trim. (Refer to Body - "Front Door Trim")

3.	Disconnect the power mirror switch connector from the door trim.

4.	Check for continuity between the terminals in each switch position as shown below. [Power Mirror Switch] [Power Folding Mirror Switch]

[IMS Type]

Diagnosis With KDS/GDS

The body electrical system can be quickly diagnosed for failed parts by using vehicle diagnostic system (KDS/GDS).

The diagnostic system (KDS/GDS) provides the following information.

(1)	Self diagnosis : Checks and displays the failure code (DTC)

(2)	Current data : Checks the system input/output data state

(3)	Actuation test : Checks the system operating condition

(4)	Additional function : Other controls such as the system option and zero point

2.	Select the 'Car model' and the system to be checked in order to check the vehicle with the tester.

3.	Select the 'Body Control Module (BCM)' to check the driver seat or assist door module (DDM/ADM).

4.	Select the "Current Data" menu to check the current state of the input/output data. The input/output data for the sensors corresponding to the driver seat or assist door module (DDM/ADM) can be checked.

5.	To check the power door lock operation by force, select "Actuation test".

Removal

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.

•	Be careful to store and handle the trim when removing/installing because lubricant and oil can leave a stain on the trim.

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front door trim. (Refer to Body - "Front Door Trim")

3.	Remove the power window switch assembly (A) after loosening the mounting screws.

Installation

1.	Install the power mirror switch assembly.

2.	Install the front door trim after connecting the connector.

3.	Connect the negative (-) battery terminal.

Power Door Mirror Switch Schematic diagrams

Circuit Diagram Driver Power Window Switch (Non-IMS Type) [Auto Folding Mirror Switch] [Non-Folding Mirror Switch] Driver Power Window Module (IMS Ty ...

Power Door Mirror Actuator Components and components location

Components 1. BSD Indicator 2. Side repeater lamp ...

Other information:

Kia Niro (DE HEV) Owners Manual: Locking
Pressing the button of the front outside door handles with all doors (and tailgate) closed and any door unlocked, locks all the doors (and tailgate). The hazard warning lights will blink once to indicate that all doors (and tailgate) are locked. The button will only operate when the smart ke ...

Kia Niro 2017 (DE HEV) Service Manual: Main Crash Pad Assembly Components and components location
Component Location 1. Crash pad main lower panel ...