Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front / rear bumper cover. (Refer to Body - "Front Bumper Cover") (Refer to Body - "Rear Bumper Cover") |
3. |
Disconnect the connector (A) from the ultrasonic sensor. [Front]
[Rear]
|
4. |
Pull out ths ultrasonic sensor (A) after opening the sensor holder (B). [Front]
[Rear]
|
Installation |
1. |
Install the ultrasonic sensor after connecting the connector. |
2. |
Install the front/rear bumper cover. |
3. |
Connect the negative (-) battery terminal. |
Kia Niro 2017 (DE HEV) Service Manual: Rear Door Inside Handle Repair procedures
Replacement
Put on gloves to protect your hands.
•
Use a plastic panel removal tool to remove interior trim pie ...
Kia Niro 2017 (DE HEV) Service Manual: Power Relay Assembly (PRA) Description and operation
Description
The Power Relay Assembly (PRA) consists of the positive and negative main relays,
pre-charge relay, pre-charge resistor and battery current sensor. It is located
inside the battery pack assembly and controls the high voltage power circuit between
the high voltage batte ...