Kia Niro: Blind spot detection / Lane change assist / Operating conditions
The indicator on the switch will illuminate when the Blind spot detection system switch is pressed with the ignition switch ON. If the vehicle speed exceeds 30 km/h (18.6 mph), the system will activate.
If you press the switch again, the switch indicator and system will be turned off.
If the ignition switch is turned OFF and ON the system returns to the previous state.
When the system is not used turn the system off by pressing the switch.
When the system is turned on the warning light will illuminate for 3 seconds on the outside rearview mirror.
Warning type
The system will activate when:
1.The system is on
2.Vehicle speed is above 30 km/h (18.6 mph)
3.Other vehicles are detected in the rear side
1st stage
If a vehicle is detected within the bounda ...
Other information:
Kia Niro 2017 (DE HEV) Service Manual: Fuel Pressure Sensor (FPS) Schematic diagrams
Circuit Diagram
Fail-Safe Mode
Item
Fail-Safe
Output Voltage (V)
12
If the fuel pressure sensor malfunctions, it enters fail safe mode. This
...
Kia Niro 2017 (DE HEV) Service Manual: Motor Control Unit(MCU) Repair procedures
Removal
•
Be sure to read and follow the “General Safety Information and
Caution” before doing any work related with the high voltage system.
Failure to follow the safety instr ...
