Removal and Installation |
1. |
Disconnect the battery negative terminal. |
2. |
Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover") |
3. |
Disconnect the oil pressure switch connector (A). |
4. |
Remove the oil pressure switch (B).
|
5. |
Install in the reverse order of removal.
|
Inspection |
1. |
Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch.
|
2. |
Check the continuity between the terminal and the body when the fine wire is pushed. If there is continuity even when the fine wire is pushed, replace the switch. |
3. |
If there is no continuity when a pressure of 50 kPa (0.50 kgf/cm², 7.25 psi) is applied through the oil hole, the switch is operating properly. Check for air leakage. If air leaks, the diaphragm is broken. Replace it.
|
Kia Niro 2017 (DE HEV) Service Manual: General safety information and caution
Precautions
General Precautions
Please read the following precautions carefully before performing the airbag
system service.
Observe the instructions described in this manual, or the airbags could accidentally
deploy and cause damage or injuries.
•
...
Kia Niro 2017 (DE HEV) Service Manual: Camshaft Position Sensor (CMPS) Description and operation
Description
Camshaft Position Sensor (CMPS) is a hall sensor, which detects the camshaft
position by using a hall element.
It is related with Crankshaft Position Sensor (CKPS) and detects the piston position
of each cylinder which cannot be detected by the CKPS.
The CMPS is inst ...