Kia Niro: AVN System / Multimedia Jack Repair procedures

Removal

Multimedia Jack

  

Put on gloves to protect your hands.

  

When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

Take care not to bend or scratch the trim and panels.

1.

Disconnect the negative (-) battery terminal.

2.

Remove the gear knob & boots (A) pull both of it up.

3.

Remove the console upper cover (A) by using a remover.

4.

Disconnect the console upper cover connector (A).

5.

Remove the console tray (A) after loosening the mounting screws.

6.

Disconnect the console tray connectors (A).

7.

Remove the multimedia jack (A) after releasing the fixed hooks.

USB Charger (Console Armrest)

  

Put on gloves to protect your hands.

  

When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

Take care not to bend or scratch the trim and panels.

1.

Disconnect the negative (-) battery terminal.

2.

Remove the floor console assembly.

(Refer to Body - "Floor Console Assembly")

3.

Disconnect the USB charger connector (A).

4.

Remove the USB charger (A) after releasing the fixed hooks.

Installation

Multimedia Jack

1.

Install the multimedia jack.

2.

Connect the console tray connectors.

3.

Install the console tray.

4.

Connect the console upper cover connectors.

5.

Install the console upper cover.

6.

Install the gear knob & boots.

7.

Connect the negative (-) battery terminal.

  

Make sure the multimedia connector and the console front tray connectors are plugged in properly.

Check the AVN system for normal operation.

USB Charger (Console Armrest)

1.

Install the USB charger.

2.

Connect the USB charger connector.

3.

Install the floor console assembly.

4.

Connect the negative (-) battery terminal.

  

Make sure that the cables and connectors are plugged in properly.

Multimedia Jack Description and operation
Description The multimedia jack on the console upper cover is for customers who like to listen to external portable music players like the MP3 etc., through the vehicle's sound sy ...

Mic Repair procedures
Inspection 1. Disconnector the negative (-) battery terminal. 2. Remove the overhead console lamp. (Refer to Lighting System - "Overhead ...

Other information:

Toyota Corolla 2019-2022 Owners Manual: Mobile Assistant operation. Mobile Assistant
The Mobile Assistant function is a voice input assist function. Mobile Assist supports the Siri Eyes Free Mode and Google App. (Google App can be used only with the corresponding device.) Instructions can be spoken into the vehicle microphone as if speaking a command to the phone. The content of ...

Kia Niro (DE HEV) Owners Manual: Distributing the sealant
11. Immediately drive approximately 7~10km (4~6miles or, about 10min) to evenly distribute the sealant in the tire. CAUTION Do not exceed a speed of 60 km/h (35 mph). If possible, do not fall below a speed of 20 km/h (12 mph). While driving, if you experience any unusual vibration, ride distu ...

© 2016-2022 www.kniro.net