Kia Niro: Engine Control System / Mass Air Flow Sensor (MAFS) Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Engine Control/Fuel System / Engine Control System / Mass Air Flow Sensor (MAFS) Repair procedures

Inspection

Visually check the MAFS for the following:

–	Correct mounting direction

–	Any contamination, corrosion or damage on connector

–	Clogged or wet air cleaner

–	Deformation or blocked MAFS cylinder by foreign material

2.	Check for any leakage on intake system and intercooler system.

Removal

1.	Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

2.	Disconnect the mass air flow sensor connector (A) and the installation clamp (B).

Remove the mass air flow sensor (C).

Mass air flow sensor mounting bolt :

3.9 - 5.8 N·m (0.4 - 0.6 kgf·m, 2.8 - 4.3 lb·ft)

Mass air flow sensor clamp mounting screw :

2.9 - 4.9 N·m (0.3 - 0.5 kgf·m, 2.2 - 3.6 lb·ft)

Installation

•	Install the component to the specified torque.

•	Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.

•	Be careful not to damage the sensing element and the honey cell.

1.	Install in the reverse order of removal.

Mass Air Flow Sensor (MAFS) Schematic diagrams

Circuit Diagram Harness Connector ...

Intake Air Temperature Sensor (IATS) Specifications

Specification Temperature Resistance (kΩ) °C °F -40 -40 40.93 - 48.35 ...

Other information:

Kia Niro (DE HEV) Owners Manual: Tilt & telescopic steering
A tilt and telescopic steering wheel allows you to adjust the steering wheel before you drive.You can also raise it to give your legs more room when you exit and enter the vehicle. The steering wheel should be positioned so that it is comfortable for you to drive, while permitting you to see ...

Toyota Corolla 2019-2023 Owners Manual: Turning the system on and off. Selecting an audio source
Turning the system on and off “POWER VOLUME” knob: Press to turn the audio/visual system on and off. The system turns on in the last mode used. Turn this knob to adjust the volume. Selecting an audio source 1 Press the “AUDIO” button. 2 Select “Source” or press “AUDIO” button agai ...